General Information - Jeep Wrangler Owner's Manual

22 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
4. Turn the ignition to the ON position ( Do not start the
engine ).
5. Press and hold the "Unlock" button on the key fob.
6. After holding the "Unlock" button for four seconds,
also press the PANIC button within 6 seconds.
7. When a single chime is heard release both buttons. The
chime is an indication that you have successfully entered
program mode. All fobs that are to be programmed must
be done so within 60 seconds of when the chime was
heard.
8. Using the fob to be programmed, press and release
both the "Lock" and "Unlock" buttons, simultaneously.
9. A single chime will be heard.
10. Within four seconds of hearing the chime, press and
release the "Unlock" button on the fob.
11. A single chime will be heard.
12. Repeat steps 8 through 10 to program up to six
additional fobs.
13. Turn the ignition to the OFF position.
14. Your vehicle will remain in program mode up to 60
seconds from when the original chime was heard. After
60 seconds, all programmed fobs function normally.
NOTE: If you do not have a programmed transmitter,
contact your dealer for details.

General Information

This device complies with part 15 of FCC rules and with
RS-210 of Industry Canada. Operation is subject to the
following conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference that may be
received including interference that may cause undesired
operation.