To Resume Speed; To Vary The Speed Setting; Manual Transmission - Jeep Wrangler Owner's Manual

To Resume Speed

To resume a previously set speed, push the "RESUME
ACCEL" lever up and release. Resume can be used at any
speed above 20 mph (32 km/h).

To Vary The Speed Setting

When the speed control is ON, speed can be increased by
pushing up and holding "RESUME ACCEL". Release the
lever when the desired speed is reached, and the new
speed will be set.
Tapping "RESUME ACCEL" once will result in a 1 mph
(1.6 km/h) speed increase. Each time the lever is tapped,
speed increases so that tapping the lever three times will
increase speed by 3 mph (4.8 km/h), etc.
To decrease speed while speed control is ON, push down
and hold "SET DECEL". Release the lever when the
desired speed is reached, and the new speed will be set.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 99
Tapping the "SET DECEL" button once will result in a 1
mph (1.6 km/h) speed decrease. Each time the button is
tapped, speed decreases.
NOTE: The Speed Control system has been designed to
shut down if multiple speed control switch functions are
operated simultaneously in order to ensure proper op-
eration. If this occurs, the system can be reactivated by
pushing the speed control switch ON/OFF button and
re-setting the desired vehicle SET speed.

Manual Transmission

Depressing the clutch pedal will disengage the speed
control. A slight increase in engine RPM before the speed
control disengages is normal.
Vehicles equipped with manual transmissions may need
to be shifted into a lower gear to climb hills without
speed loss.
3