Table of Contents
Advertisement
User's Manual
8037 Programmable keyboard
Once all connections are complete, and then turn on your computer. It should boot up normally.
The keyboard will "beep" three
times. The keyboard is now ready for programming.
Turn to Chapter 3.
Programming via the Keyboard Port
Turn off your computer to avoid any accidental damage to the keyboard. Refer to the keyboard
installation shown in Diagram 2.2.
Unplug the QWERTY keyboard cable from your computer. Plug the QWERTY keyboard cable
into female side of the Y cable on the Jarltech keyboard
cable. Plug the male end of the Y cable
into the keyboard
port of your computer.
Once all connections are complete, turn on your computer. It should boot up normally.
The
keyboard will "beep" three times.
The keyboard is now ready for programming.
Turn to Chapter 3.
Keyboard
port
Diagram 2.2
CHAPTER 3
8
Advertisement
Table of Contents
