Table of Contents
Advertisement
In Case Of Difficulty
Common cure for electronic equipment
If the unit does not seem to be responding normally, then try putting the handset in its
base. If it does not seem to respond, do the following (in the order listed):
1. Disconnect the power to the base.
2. Disconnect the handset battery.
3. Wait a few minutes.
4. Connect power to the base.
5. Re-install the battery(ies).
6. Wait for the handset to re-establish its link with the base. To be safe, allow up to
one minute for this to take place.
Your answering system is not recording messages
•
Make sure system is turned ON (the ON/OFF key is illuminated).
•
Make sure the Announce Only feature is set to OFF.
You cannot hear recorded messages
•
Using the base volume control, raise the volume to a comfortable listening level.
CL is flashing in the base Message Window Display:
•
You need to set the day and time. Refer to the section(s) on setting day and time in
this user's manual.
34
Advertisement
Table of Contents
