Yamaha FZ6RZ(C) Owner's Manual page 65

1
1. Coolant reservoir cap
2. Coolant reservoir breather hose
3. Guide
6. Remove the coolant reservoir cov-
er and coolant reservoir by remov-
ing the bolts.
1
1. Bolt
2. Coolant reservoir cover
3. Coolant reservoir
PERIODIC MAINTENANCE AND ADJUSTMENT
7. Drain the coolant from the coolant
reservoir by turning it upside down.
8. Remove the coolant drain bolt and
its gasket to drain the cooling sys-
2
tem.
3
1. Coolant drain bolt
2. Gasket
9. After the coolant is completely
drained, thoroughly flush the cool-
ing system with clean tap water.
10. Install the coolant drain bolt and its
2
new gasket, and then tighten the
bolt to the specified torque.
3
Tightening torque:
Coolant drain bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
11. Install the coolant reservoir and its
12. Pour the specified amount of the
2
1
13. Install the radiator cap.
14. Install the coolant reservoir cap.
15. Start the engine, let it idle for sev-
16. Remove the radiator cap to check
7-18
cover by placing them in the origi-
nal position, and then installing the
bolts.
recommended coolant into the ra-
diator and reservoir.
Antifreeze/water mixture ratio:
1:1
Recommended antifreeze:
High-quality ethylene glycol anti-
freeze containing corrosion inhibi-
tors for aluminum engines
Coolant quantity:
Radiator capacity (including all
routes):
2.00 L (2.11 US qt, 1.76 Imp.qt)
Coolant reservoir capacity (up to the
maximum level mark):
0.25 L (0.26 US qt, 0.22 Imp.qt)
eral minutes, and then turn it off.
the coolant level in the radiator. If
necessary, add sufficient coolant
7