VMware VS4-ENT-PL-A - vSphere Enterprise Plus Setup Manual page 141

6 Press Enter to start the installation.
7 When the installation is complete, remove the installation CD, DVD, or USB flash drive.
8 Press Enter to reboot the host.
If you are performing a new installation, or you chose to overwrite an existing VMFS datastore, during
the reboot operation, VFAT scratch and VMFS partitions are created on the host disk.
9 Set the first boot device to be the drive on which you installed ESXi in
For information about changing boot order, see your hardware vendor documentation.
N UEFI systems might require additional steps to set the boot device. See
OTE
You Install ESXi in UEFI Mode,"
After the installation is complete, you can migrate existing VMFS data to the ESXi host.
You can boot a single machine from each ESXi image. Booting multiple devices from a single shared ESXi
image is not supported.
What to do next
Set up basic administration and network configuration for ESXi. See
Up ESXi," on page 267.
Install ESXi on a Software iSCSI Disk
When you install ESXi to a software iSCSI disk, you must configure the target iSCSI qualified name (IQN).
During system boot, the system performs a Power-On Self Test (POST), and begins booting the adapters in
the order specified in the system BIOS. When the boot order comes to the iSCSI Boot Firmware Table (iBFT)
adapter, the adapter attempts to connect to the target, but does not boot from it. See Prerequisites.
If the connection to the iSCSI target is successful, the iSCSI boot firmware saves the iSCSI boot configuration
in the iBFT. The next adapter to boot must be the ESXi installation media, either a mounted ISO image or a
physical CD-ROM.
Prerequisites
Verify that the target IQN is configured in the iBFT BIOS target parameter setting. This setting is in the
n
option ROM of the network interface card (NIC) to be used for the iSCSI LUN. See the vendor
documentation for your system.
Disable the iBFT adapter option to boot to the iSCSI target. This action is necessary to make sure that
n
the ESXi installer boots, rather than the iSCSI target. When you start your system, follow the prompt to
log in to your iBFT adapter and disable the option to boot to the iSCSI target. See the vendor
documentation for your system and iBFT adapter. After you finish the ESXi installation, you can
reenable the option to boot from the LUN you install ESXi on.
Procedure
1 Start an interactive installation from the ESXi installation CD/DVD or mounted ISO image.
2 On the Select a Disk screen, select the iSCSI target you specified in the iBFT BIOS target parameter
setting.
If the target does not appear in this menu, make sure that the TCP/IP and initiator iSCSI IQN settings
are correct. Check the network Access Control List (ACL) and confirm that the adapter has adequate
permissions to access the target.
3 Follow the prompts to complete the installation.
4 Reboot the host.
VMware, Inc.
on page 252
Chapter 7 Installing ESXi
Step 3.
"Host Fails to Boot After
Chapter 9, "After You Install and Set
141