Attaching The Arm Cuff; How To Take Proper Measurements; Measurement; After Measurement - A&D UA-704 Instruction Manual

Attaching The Arm Cuff

1. Wrap the cuff around the upper arm,
about 2 - 3 cm above the elbow, as
shown. Place the cuff directly against
the skin, as clothing may cause a faint
pulse and result in a measurement error.
2. Constriction of the upper arm, caused
by rolling up a shirtsleeve, may prevent
accurate readings.
3. Confirm that the index
the proper fit range.

How To Take Proper Measurements

For the most accurate blood
pressure measurement:
Sit comfortably at a table.
Rest your arm on the table.
Relax for about five to ten minutes before measurement.
Place the center of the cuff at the same height as your heart.
Remain still and keep quiet during measurement.
Do not measure right after physical exercise or a bath. Rest for twenty or
thirty minutes before taking the measurement.
Try to measure your blood pressure at the same time every day.

Measurement

During measurement, it is normal for the cuff to feel very tight.
Measure your blood pressure according to the section "Measurements".

After Measurement

Press the exhaust valve to exhaust air from the cuff.
Press the
START
Remove the cuff and record your data.
Note: The device has an automatic power shut-off function, which turns off the
power automatically one minute after measurement.
Allow at least three minutes between measurements on the same person.
Using The Monitor
points within
button to turn off the power a
ENGLISH 6
Rolled up shirtsleeve
Cuff
2 -3 cm
Constriction of the Upper Arm
Index and Proper fit range
fter the measurement.
Air Hose