Table 80 Extended Self-Test Log Descriptor Entry; Table 81 Command Error Information - Hitachi 2.5 inch SATA Travelstar HTS543232L9A300 Oem Specification

14.17.3.2
This indicates the most recent self-test descriptor. If there have been no self-tests, this is set to zero.
Valid values for the Self -test descriptor index are 0 to 18.
14.17.3.3
The content of the self-test descriptor entry is shown below.
Description
Self-test number
Self-test execution status
Power-on life timestamp in hours
Self-test failure check point
Failing LBA (7:0)
Failing LBA (15:8)
Failing LBA (23:16)
Failing LBA (31:24)
Failing LBA (39:32)
Failing LBA (47:40)
Vendor specific

Table 80 Extended Self-test log descriptor entry

Command Error
14.17.4
The following table defines the format of the Command Error data structure.
Byte
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14 – 255
256 – 510
511

Table 81 Command Error information

The TAG field (Byte 0 bits 4-0) contains the tag number corresponding to a queued command, if the
NQ bit is cleared.
The NQ field (Byte 0 bit 7) indicates whether the error condition was a result of a non-queued or not.
If it is cleared, the error information corresponds to a queued command specified by the tag number
indicated in the TAG field.
Self-test descriptor index
Extended Self-test log descriptor entry
7 6 5
NQ Rsv Rsv
Sector Count Previous
Data Structure Checksum
5K320 SATA OEM Specification
4 3
Reserved
Status
Error
LBA Low
LBA Mid
LBA High
Device
LBA Low Previous
LBA Mid Previous
LBA High Previous
Reserved
Sector Count
Reserved
Vendor Unique
115
Bytes Offset
1 00h
1 01h
2 02h
1 04h
1 05h
1 06h
1 07h
1 08h
1 09h
1 0Ah
15 0Bh
26
2 1 0
TAG