14.17.3.2
This indicates the most recent self-test descriptor. If there have been no self-tests, this is set to zero.
Valid values for the Self-test descriptor index are 0 to 18.
14.17.3.3
The content of the self-test descriptor entry is shown below.
Description
Self-test number
Self-test execution status
Power-on life timestamp in hours
Self-test failure check point
Failing LBA (7:0)
Failing LBA (15:8)
Failing LBA (23:16)
Failing LBA (31:24)
Failing LBA (39:32)
Failing LBA (47:40)
Vendor specific
Table 80 Extended Self-test log descriptor entry
Command Error
14.17.4
The following table defines the format of the Command Error data structure.
Byte
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14 – 255
256 – 510
511
Table 81 Command Error information
The TAG field (Byte 0 bits 4-0) contains the tag number corresponding to a queued command, if the
NQ bit is cleared.
The NQ field (Byte 0 bit 7) indicates whether the error condition was a result of a non-queued or not.
If it is cleared, the error information corresponds to a queued command specified by the tag number
indicated in the TAG field.
The bytes 1 to 13 correspond to the contents of Shadow Register Block when the error was reported.
Self-test descripto
Extended Self-test log descript
7
6
NQ
Rsv
Rsv
Data Structure Checksum
r index
5
4
3
Reserved
Status
Error
LBA Low
LBA Mid
LBA High
Device
LBA Low Previous
LBA Mid Previous
LBA High Previous
Reserved
Sector Count
Sector Count Previous
Reserved
Vendor Unique
115
5K320 SATA OEM Specification
or entry
Bytes Offset
1
1
2
1
1
1
1
1
1
1
15
26
2
1
TAG
00h
01h
02h
04h
05h
06h
07h
08h
09h
0Ah
0Bh
0