Native Command Queuing; Smart Command Transport (Sct); Table 38 Preserved Software Setting - Hitachi Travelstar 5K320 HTS543232L9A300 Manual

Setting
Initialize device parameters
Power Management Feature Set Standby
Timer
Security mode state
Set max address
Set feature
Set multiple mode

Table 38 Preserved Software Setting

12.16

Native Command Queuing

Native Command Queuing feature (Read / Write FPDMA Queued commands) is supported. Please
refer to the Serial ATA II Specification about Native Command Queuing.
The host shall not issue a legacy ATA command while a native queued command is outstanding.
Upon receiving a legacy ATA command while a native queued command is outstanding, the device
aborts the command and halts command processing of outstanding native queued commands.
12.17

SMART Command Transport (SCT)

SMART Command Transport (SCT) feature set is supported. The SMART Read Log and SMART
Write Log commands or Read Log Ext and Write Log Ext commands are used to issue a command in
this feature sets. Log page E0h is used to issue commands and return status. Log page E1h is
used to transport data.
specification for more detail.
The following Action codes are supported.
Action code
0002h Write Same command
Please refer to the section 8 SCT Command Transport in ATA8-ACS
Description
- 70 -
5K320 SATA OEM Specification
Contents
Track length
Number of head
Number of cylinder
Capacity
Time to fall into standby mode
Security freeze lock
Security unlock
Capacity
Write Cache Enable/Disable
Set Transfer Mode
Advanced Power Management
Enable/Disable
Read Look-Ahead
Reverting to Defaults
Block size