Remote Panic Feature - Omega K9-Classic-E Owner's Manual

Upper Left "arm/lock" Button =
lowest chirp volume (8mS);
system responds with 1 chirp
Lower Left " II " Button =
medium high chirp
volume (30mS); system
responds with 3 chirps
(default setting)
Feature #20 Total Closure Lock Output
This is another installation-related feature, provided for the installer's use only. Should the vehicle
have an existing "Total Closure" feature, this programmable feature gives the installer the option of
configuring the K-9 to operate this feature. Typically, on vehicles having total closure, when locking
the vehicle's doors if the key in the door is held to "lock" for a period of time the vehicle will close all
windows and the sunroof, in addition to locking the doors. Should your vehicle be equipped with this
operation, please inquire with the installer if it is possible to interface the K-9 with the vehicle's total
closure operation.
Turning this feature on changes the system's door lock output pulse from a .75 second pulse to be
a 28 second duration output. Note: When this feature is turned on, during the 28 second period after
arming the system, should either Upper Button be pressed, "Lock" or "Unlock", only the system's
lock output will be stopped. Pressing either button again will normally operate the system, and at any
time after the 28 second lock output period ends.
Upper Right "disarm/unlock" Button =
medium low chirp volume (12mS);
system responds with 2 chirps
the buttons can be repeat-
edly and sequentially
Lower Right " III " Button=
pressed, thus making it
highest chirp volume (50mS);
easy to hear and choose
system responds with
the setting with the best
4 chirps
chirp volume.
(Default Setting OFF)
Page - 30
ignition key "on". Also, Automatic Rearming can be cancelled by the Safety Disarm/Storm Mode
feature; if the system is disarmed while triggered, Automatic Rearming will not occur. Automatic
While program-
Rearming is confirmed by a fast flashing Status Light after disarming, unless the system was triggered,
ming this feature,
in which case a Zone Violation code will flash instead.
Disarming the System by Emergency Override
Should the transmitter become lost, damaged, or its batteries become exhausted, the Valet Switch
and the vehicle's ignition key may be used to disarm the system:
Step 1 With the system in the armed condition, enter the vehicle via the driver's door (be aware that
the system will activate to an alarm condition when the door is opened).
Step 2 Using the ignition key, turn the vehicle's ignition switch on.
Step 3 Within 5 seconds press and release the Valet Switch one time. The system will disarm.
The number of Valet Switch presses which are required for the Emergency Override is custom-
programmable! This is the SecureCode feature, which is described on page 14. The above
Emergency Override instructions reflect the "as received from the factory" default setting.
Should you feel threatened, or the need to attract attention, you can activate your system's remote
"Panic" feature at any time by pressing and holding for 3 seconds any of these three transmitter buttons:
"arm/lock", "disarm/unlock" or the red "III" button. Your system will respond by sounding the siren
and flashing the parking lights for the normal activated alarm period of 30 seconds. Further, the K-9
system features an unique "enhanced" remote Panic operation, regarding additional operations during

Remote Panic Feature

Page - 11