Moisture Selector; On Signal Light - GE PKD915 Owner's Manual

Using the warming drawer. GEAppliances.c
The warming drawer will keep hot, cooked foods at serving temperature. Alwags start with hot food. Do not use to
heat cold food other than proofing yeast dough, crisping crackers, chips or drg cereal.
Control Knob
q3_
The warming drawer controls are hidden with
the drawer shut. Open the drawer. The controls
are on the right side of the front frame.
To use the warming drawer, press the ON/OFF
switch to the ON position.
Slide the moisture selector control to the open
or closed setting. (See the Moisture Selector
section.)
Turn the control knob to the desired settinc
PROOF .................... 75-95°F
LOW ...................... !40-!60°F
MED ...................... !60-!95°F
HIGH ..................... !95-230°F
ON Signal Light
The ON signal light is located below the ON/OFF
switch and glows when the ON/OFF switch is
in the ON position. It stags on until the ON/OFF
switch is moved to the OFF position.
The ON signal light is visible through the light
viewer in the drawer front panel when the
drawer is closed. This is a reminder that the
heat is on.
Moisture Selector
The moisture selector is located on the inside
front of the drawer.
To keepfoods moist, slide the moisture selector
control awag from the control knob. This closes
the vent and seals the moisture inside the
drawer. With the vent closed hot foods stag
moist and soft.
In this setting condensation mag occur around
the inside edge of the drawer.
To keep foods crisp, slide the moisture selector
control to the right towards the control knob.
This opens the vents and allows the moisture
to escape.
With the vents open, it is normal for moisture to
collect on surfaces above the warming drawer.