GE PKD915 Owner's Manual page 14

Installation of the warming drawer.
Read these instructions completely and carefully.
Provide Cabinet Support
2" x 4" or equivalent runners
1 I
I
' _:
i:
i:
i:
i
i
i
I_
22'
I
27"
23½"
23!"
2" X
a II
or
equivalent
runners
i
I_ 2s'_
30" _,-
IMPORTANT:When installed below a single or double oven,
check to be sure that ang oven supports above the cutout do
not obstruct the 23½" required depth of the warming drawer
cutout.
, A 2 'l minimum clearance between oven and warming
drawer cutouts (]re required. Additional clearance may be
required if 2 x/4 blocks are used to support runners or solid
floor of the oven above.
The warming drawer may be supported by either u solid
bottom, 2 x 4 or 2 x 2 runners.
The support must be level and rigidly mounted, flush with
the bottom edge of the cutout.
There is no wag to level the drawer once it has been
installed. Be sure supports are level.
The entire weight of the drawer is supported by the
runners or solid floor and must be capable of supporting
150 Ibs.
Step i-Install Anti-Tip Brace
WARNING: ANTI-TIP PRECAUTIONS:
The anti-tip brace must be installed to prevent the drawer
from tipping forward when opened and loaded.
Failure to do so could result in personal injurg.
T" Install 2x4 or 2x2 antFtip
\ brace against rear cabinet
\ wall 9" from floor to
bottom of ]ce
,___ 2x4 or 2x2 runners ___
or solid bottom
14