Table of Contents
Advertisement
Components
Item
Network Port
Alarm I/O Port
Test Monitor Out
Reset Button
Used to connect the PoE or Ethernet cable for network connection.
ALARM IN
Used to connect the alarm input signal.
ALARM OUT
Used to connect the alarm output signal.
GND
Used for earth-grounding.
Output port for test monitoring the video output. Use the test monitor cable
to connect to a mobile display and check the test video.
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
J
If you reset the camera, the network settings will be adjusted so that
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
Description
English _23
Advertisement
Table of Contents
