Table of Contents
Advertisement
appendix
PROBLEM
<Motion detection / Video
analytics> of <Event setup> is set
to <Enable>, but no notification
e-mail reaches me even when an
analysis event had occurred.
Can I define event rules even
when I don't use <Motion
detection / Video analytics>?
No signal is found at the Alarm
Output port even when an
intelligent video analysis event is
generated.
Cannot record into the SD memory
card.
SD memory card is inserted but
the camera does not operate
properly.
Cannot format the SD memory
card.
134_ appendix
Verify the settings in the following sequence:
A. Check <Data & Time> settings.
B. The <Motion detection / Video analytics> should be set to <Enable>.
C. Check if the <E-mail> option of <Event action setup> menu is
checked to use.
Yes, it can be. You can set rules for events despite of the intelligent
video analysis setting.
Check alarm output port settings.
Check if the memory card is defective.
Check if the write protection tab of the memory card is set to "LOCK".
Check if the memory card is inserted in the proper direction. Operation
of memory card that is formatted by other devices is not guaranteed with
this camera unit
Format the memory card again in <Setup> <Event> <Storage>
menu.
Check if the write protection tab of the memory card is set to "LOCK".
SOLUTION
Advertisement
Table of Contents
