Table of Contents
Advertisement
Item
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
J
Reset Button
Focus Adjustment
The button adjusts the focus of image automatically.
Button
Power Port
Used to plug the power cable.
Lightning protective
Used to discharge the lightning current safely outside in order to protect the
grounding port
camera.
Network Port
Used to connect the PoE or Ethernet cable for network connection.
ALARM IN
Alarm I/O Port
ALARM OUT
GND
Output port for test monitoring the video output. Use the test monitor cable
Test Monitor Out
to connect to a mobile display and check the test video.
If you reset the camera, the network settings will be adjusted so that
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can connect
to the network.
Used to connect the alarm input signal.
Used to connect the alarm output signal.
Used for earth-grounding.
Description
English _17
Advertisement
Table of Contents
