Kenmore 417.4413 Use & Care Manual page 24

Solutions to Common Problems
Common Washing Problems, continued
PROBLEM POSSIBLE CAUSES SOLUTIONS PREVENTIVE MEASURES
Yellow buildup
of body soil on
synthetic fabrics
Yellow or brown
rust stains
Residue stains / •
buildup, mold or •
mildew stains in •
gasket •
Residue stains / •
buildup, mold or •
mildew stains in •
dispenser drawer
Water in fold of •
flexible gasket
Odor •
• Agitation time too short.
• Wash water temperature
too low.
• Not enough detergent.
• Iron or manganese in water
supply, water pipes, or water
heater.
Moisture in the washer.
Use of non-HE detergent.
Overdosing detergent.
Overloading wash drum.
Leaving a wet load set in
washer.
Cold water washes which
may not completely dissolve
and remove detergents.
Moisture in the washer.
Use of non-HE detergent.
Overdosing detergent.
Result of washing and part
of normal operation.
Moisture in the washer.
Use of non-HE detergent.
Overdosing detergent.
Leaving a wet load remain
in washer.
Cold water washes which
may not completely dissolve
and remove detergents.
• Soak in detergent booster or product
containing enzymes.
• Wash in hottest water safe for fabric
using casual cycle.
• Increase detergent.
• Add bleach safe for fabric or treat
with color remover.
To restore discolored load of whites,
use rust remover safe for fabric.
Do not use chlorine bleach to remove
rust stains. It may intensify discolor-
ation.
• Perform Clean Washer cycle
• Scrub gasket with Comet
TM
Spray Gel
Mildew Stain Remover using brush to
remove stains.
• Use only HE (high efficiency detergent)
along with recommended dosage.
• Remove wash load immediately upon
cycle completion.
• Remove dispenser drawer and wipe
dispenser and inserts with combination
of 3¼ cup liquid chlorine bleach and
one gallon hot water. Rinse well, and
repeat if necessary. Return drawer to
location. NOTE: Wear rubber of latex
gloves. Protect floor and clothing from
bleach damage.
• Use only HE (high efficiency detergent)
along with recommended dosage.
• At the end of each wash, dry inside
of gasket fold with clean dry towel all
around gasket.
• Perform Clean Washer cycle.
• At the end of each wash, dry inside of
gasket fold with clean, dry towel all
around gasket.
•
Use only HE (high efficiency detergent)
along with recommended dosage.
• Remove wash load immediately upon
cycle completion.
• Pour one cup liquid chlorine bleach in
standpipe; let remain a day and flush
with water.
• Select correct wash cycle.
• Use correct amount of detergent.
• Wash synthetics frequently using
hot or warm water.
• Use nonprecipitating water soft-
ened
• Before washing, run hot water for
a few minutes to clear lines.
• Drain water heater occasionally.
• }:or an ongoing problem, install
an iron filter in your water supply
system.
• Run dehumidifier in laundry room.
• Avoid overfilling detergent and
fabric softener compartments of
dispenser.
• Dry the inside of washer and gas-
ket after every run.
Avoid overfilling detergent and
fabric softener compartments of
dispenser.
Leave door and dispenser drawer
open for a few hours after use or
whenever washer is not in use.
24