DeVilbiss EXH2425 Operator's Manual page 8

1. Connect handle to frame.
OR
i
TO ASSEMBLE ACCESSORIES PANEL
(if equipped)
1. Remove top screws on handle assembly.
2. Loosen bottom screws on handle assembly.
2. Connect wand to gun. Tighten securely.
3.
.
Attach high pressure hose to gun. NOTE: The
point of attachment for the high pressure hose will
differ depending on the model purchased. Tighten
securely.
OR
Add engine oil (supplied) to engine. Refer
to engine manual supplied by engine man-
ufacturer for procedure. Do not overfill.
Use of a funnel is recommended.
NOTE: There will be a slight amount of oil
in the engine from factory testing.
NOTE: The pump was filled with oil at the
factory. There is no need to add oil at this
time, see the Maintenance section of this
manual to perform maintenance on this
pump.
3. Place grooves in accessories panel assembly
onto screws and slide panel assembly into place.
4. Place screws (removed earlier) into the top holes
and secure accessories panel assembly to han-
dles. Do not overtighten.
Screws
--i _ Accessories
---._..
8 -- ENG