Troubleshooting; The Washer-Dryer Fails To Start; The Washer-Dryer Fails To Fill With Water; The Washer-Dryer Continuously Fills And Drains Water - Ariston AWD121 User Instructions

Troubleshooting
In most cases, when your _washerodryer fails to work, the problems arising can be easily solved
without having to call for a technician. Before calling for assistance, always check these points.
The washer-dryer fails
to start.
N_Is the plug correctly inserted
into the socket? Itcould have
been moved while cleaning.
NJls there emectricRy [n the
house?
A circuit breaker may have
switched off as a result of too
many electrical appliances
working at the same time. Or
maybe due to a general failure
in your entire area.
Nls the washerodryer door
emceedpropermy?
For safety reasons, the
washer-dryer cannot work if
the door is open or not shut
properly.
N_[s the OnlOff button
pressed?
If it is, then a program has
been set.
N_[s the Washer knob in the
correct position for those
modems concerned?
@is the water supply turned
on? For safety reasons, if the
washer-dryer does not load
water, it cannot start a wash
cycle.
Turn off the water
supply _'ter use+
This will eliminate
the possibility of
leakage.
Always leave the
appliance door ajar to
avoid bad odou_.
Clean the app!iance's
e×teriors gently.
3[i_clean the
e×teriors and the
rubber parts of the
appliance, always use
a soJ_cloth dipped in
warm and soapy
watea
You will be charged for a service call while the
appliance is in warranty if the proNem is not
caused by defective workmanship or materiNs,
But where did aH the water ge?
Simple: with the new Ariston technology, you need Bose
than half of it, to get good results on twice as much!
This is why you cannot see the water through the door:
because there is Httle, very
[ittmeof it, to respect the
environment yet without
renouncing maximum
cleanliness.
And, on top of that, you are
also saving electricity.
f
off, select one of the
positions stop/Reset, then
switch it back on. If the knob
continues to turn, call for
assistance because it is
showing an anomaly.
The washer-dr'€or fails
to fill with water.
N_[s the hose correctly
connected to the tap?
@Is there a water shortage ?
There could be work in
progress in your building or
street.
@Is there sufficient water
pressure? The autoclave
may be malfunctioning.
@Is the tap filter clean? If the
water is very calcareous, or
if work has recently been
carried out on the water
piping, the tap filter could be
clogged with particles and
debris.
_[s the rubber hose kinked?
The rubber hose bringing
water to washer-dryer must
be as straight as possible.
Make sure it is not squashed
or kinked.
The Washer knob
keeps turning?
N_Wait a few minutes for the
drain pump to empty the
tub, switch the washer-dryer
The washer-dryer
continuously
fills and
drains water.
@ Js the drain hose positioned
too mow? It must be instaIIed
at a height ranging from 25"
to 34" (62 to 86 cms.).
@ Is the end of the hose
immersed in water?
@ Does the wall drainage
system have a breather
pipe? if the problem persists
even after these checks, turn
the water supply off the
machine and call for
assistance.
If you live on an upper floor
of your building, there may be
a problem with your drain
trap.
To solve this probIem, a
special valve must be
installed.
16 lnstructionsforinstallationanduse www.aristonapptianees.us