Advertisement
Available languages
Available languages
You should s elect the wash/rinse
water temperature
based o nthetype ofload you arewashing. Always use
the warmest wash water safe forfabric a nd follow
garment label instructions.
Depending
onlocation, water
temperatures
may vary byseason. The fillrate may also
differ depending
onthewater temperature
selected.
The Cycle S elector (Timer) Control Knob i sused toselect your
wash/rinse
water temperatures.
Allrinses a re cold tosave
energy.
For h ot w ater wash, you should s elect SUPER.
For w arm water wash, you should s elect REGULAR.
For c old water wash, you should select SHORT
8YSLIIE SELIIEST@/(TIMI£À} 881T/@L
Permanent
Press
I
This cycle will give you up to 10 minutes of wash time
and provides a load-cooling spray rinse to reduce
wrinkling.
Heavy
Duty
Use this cycle for sturdy or heavily soiled loads. For the
maximum soil removal, you should set the Cycle Selector
(Timer) Control for the longest available time.
Rinse
& Spin
Select this option if you think an extra rinse is needed. Set
OPTIONS Control (if available) to One Rinse. You should then
set the Cycle Selector (Timer) Control knob to a Rinse setting.
Spin Only
A drain and spin may help shorten drying times for some fabrics
by removing excess water. Set OPTIONS Control (if available)
to One Rinse. You should then set Cycle Selector (Timer)
Control to a Spin setting.
TISIILE$tOOTiNI
= 881N#$ ant LEAR$
Before you call service...check
for the following.
Loud clicking and banging?
• The yellow shipping strap may still be in the rear of the
washer. Completely remove the yellow shipping strap.
• The washer should be level, and the feet should be firmly
on the floor.
Some sounds are normal but may be different from
those of your previous washer.
• The gears engaging after the drain and before the spin.
• The sound of air being pulled through the pump after most
of the water has drained.
Is the washer leaking?
• Fill hose connections are tight
• Gaskets in fill hose are tight and flat
• Drain hose clamp is securely attached
• Faucets, drain/standpipe or laundry tub is not leaking
• The washer tub is centered, and the load evenly balanced
at the start of each load
• The washer is level
• The front feet are installed, and the nuts are tightened
to the cabinet
See the Use and Care Guide for complete details.
8566916
® Registered Trademark
/ TM Trademark / SM Service Mark of
3/05
@ 2005 Sears
Roebuck and Co.
Sears
Roebuck and Co. used under licensee by Sears Canada Inc.
Printed in U.S.A
Advertisement
