Display Unit Connections - Furuno 1932 MARK-2 Installation Manual

7. Unfasten four screws shown in the figure
below.
Figure 2-5 Scanner unit chassis,
cover opened
8. Pass the signal cable through the cable
protector.
Figure 2-6 Scanner unit chassis,
cover opened

2.2 Display Unit Connections

Power cable connector
Signal cable connector
(DJ-1, waterproof)
2-2
Four screws
Cable
protector
Left: HDG connector
Middle: NMEA connector (for NAV)
Right: NMEA connector (for E/S)
Figure 2-8 Connection on the display unit
9. Connect the signal cable to the RTB
Board (03P9249), referring to the inter-
connection diagram and the figure below.
Note that connector VH2P is not used.
10.Attach three EMI cores to the signal cable
as shown below.
Lead in
cable here.
EMI core
RFC-13
Route cable along here.
Figure 2-7 Scanner unit chassis,
cover opened
11. Fix the signal cable with the cable clamp.
12.Release the stay and close the cover.
Loosely fasten the cover fixing screws;
you will have to make some adjustments
inside after completion of wiring.
External equipment
connector
(For Remote Display,
External Alarm Buzzer
OP03-21 and Radar
Plotter, RP-110)
Ground terminal
CAUTION
Ground the equipment to prevent
mutual interference.
J821 VH9P
J824 NH13P
J823 VH4P
Clamp