Furuno NAVIONICS GP-1650WDF Operator's Manual page 82

11. CUSTOMIZING YOUR UNIT
UPLOAD/DOWNLOAD DATA menu
This menu allows you to upload waypoint
and route data to a PC or download the
same data from a PC, via the DGPS
connector at the back of display unit. The
menu can be displayed by pressing the
[MENU] key followed by the
CONFIGURATION and
UPLOAD/DOWNLOAD DATA soft keys. For
detailed information, see the Installation
Manual. For SAVE DATA TO MEMORY
CARD and LOAD DATA FROM MEMORY
CARD, see chapter 10.
DOWNLOAD WPT/RTE TO PC
UPLOAD WPT/RTE FROM PC
SAVE DATA TO MEMORY CARD
LOAD DATA FROM MEMORY CARD
DGPS 3D
Upload/download menu
ANT XDR
Connect PC to DGPS.
Display unit, rear view
11-12
DWNLOAD
UPLOAD
RETURN
+
13GND
2
-
12-24
VDC
DGPS NMEA
Set communication software on the PC as
follows:
Baud Rate: 4800 bps
Character Length: 8 bit
Stop bit: 1 bit
Parity: None
X Control: XON/XOFF
The following data can be
downloaded/uploaded between a personal
computer and this equipment:
Waypoint data (In alphanumeric order)
Route data (In order of route number)
End of sentence
Note 1: There are two kinds of data for
route data: route data and route
comment data.
Note 2: DGPS position fix is not available
when uploading or downloading
data.
Download waypoint/route to PC
1. Connect the PC to the GP-1650W series
as shown on the next page.
2. Press the DOWNLOAD WPT/RTE TO
PC soft key. You are asked if you are
ready to download waypoints and routes.
3. Press the [ENTER] key to download.
Upload waypoint/route from PC
Note that all waypoint and route data stored
in this unit will be deleted when data is
uploaded.
1. Connect the PC to the GP-1650W series
as shown below.
2. Press the UPLOAD WPT/RTE FROM PC
soft key. You are asked if you are ready
to upload waypoints and routes.
3. Press the [ENTER] key to upload.