Feed Dog Height; Feed Timing; Upper Knife Tihing - Kenmore 365.1664194 Information Manual

FEEDTININO prPEH°KN_FETIHIN_
CORRECTSETTING
MIEN TIlE TIP OF NIGHT NEEDLE 15 AT 2 I.l,I (5/6q") ABOVE TIlE NEEDLE PLME IN
ITS DOWNWARD MOTION AND LOWEREDPRESSER FOOT. THE TOP OF TIlE F_ED DOG
TEETH SHOULD BE LEVEL TO THE TOP SUEFACEOF NEEDLE PLATE _¢ THEIH EEAEMOST
POSITZON.
TO ADJUST
Io SET Tile STITCII LENGTH DIAL AT "4" AND TIIF DIEFEEENTIAL FEED DIAL
AY "l.O".
2, RAISE TH_ PPtSSER FOOT AND MOVE THE NEEDLE TO TIIE POSITION o?
THAT TIIE TIP OF THE RIGIIT NEEDLE IS AT P _ (b/6_I"} AROVI _li[:
NEEDLE PLATE IN ITS DOWNWARD MOTION.
_. LOWERED THE PRE,SSERFour AND LOOSEN THE _Wo SCREWS (C) AND ADJUSl
THE POSITION OF THE FEED cAN WHILE AIMING THE GUIDE LILIES.
• TURN THE FEED CAHTO THE DIRECTION "A" IF THE FEED DOGS ARE
LOWERTHAN THE SURFACEOF TIlE NEEDLE PLATE.
I TURMTHE FEED CAM TO TIIEDIRECTION "B" IF THE FEED DOGS ARE
HIGHER THAN THE SURFACE OF THE NEEDLE PLATE.
4, TIGHTEN THE TWO SCP, EWS (C) FIRMLY.
Tof OF
FEED DOG
GUIDE LINES
B
FEED CAM
COLLECT _ET'I'ING
THE UPFEE KNIFE TIMING IS THE SANE AS TIIAT O_ THE NEEDLE BAE. IN FACT,
WBE_ THE NEEDLE BAR IS AT ITS HIGIIF.%T POSITION TIlE UPPER KNIFE EII_ULU BE
ALSO AT ITS HIGHEST POSITION.
7_Q_DJUST
1. REMOVE Tile MACHINE BASE. (REtLE _o PAGE IS.)
2. LOOSENTHE TWOSET SCREWS(A) AND
• TUBN THE UPPER KNIFE DELVE CAH TO THE DIEECTION '(A)* _IEII
THE UPPER KNIFE TIMING IS BEING DELAY.
•
TURN 7tie UPPER KNIFE DELVE CAN TO Tile DIRECTION '_' WHEN
TEE UPPEH KNIFE TIMING IS TOO,SOON,
3. TIGHTEN THE '1140_ET _CREW_ (A) FIRMLY,
TUEEE SHOULD BE I 1414 C LEARANCE BETWEEN UPPER KNIFE DRIVE CAM AND
BUSHING.
4, TURN THE BALANCE WHEEL _WAHD YOU ONE C%CLE, AND B=CHECK THE
UPPER KNIFE TIMINg,
5. ATTACH THE MACHINE BASE.(P.EFER TO PAGE 15,)
NHE_i THE 14EEULEBAE GoES UP,
THE UPPER KNIPI e.GOES UP.
WHEN 'l'llE FEEBLE EAR GOES DOWN,
THE UPPER KNIFE ALSO GOES DJWN.
A