How To Arm The System; How To Arm Multiple Partitions - Honeywell Tuxedo Touch Series Home Automation System User Manual

How to Arm the System

Arming the system in any mode is performed in the same way, as described below.
Note: Close all perimeter windows and doors before arming.
Arm the system as follows:
ICON
1. From the "Home" screen, press the
SECURITY icon.
2. Press the selected arming icon.
-a text message appears stating which zones are
arming and whether or not there is an entry delay
-the screen changes to display the remaining exit
delay time, and
-the exit delay time continues to count down to one.
Note: For CP-01 installations, Maximum Mode cannot be used.

How to Arm Multiple Partitions

Note: Some systems may not have multiple partitions and the "Arm Multi-Partitions" icon may not be displayed.
To arm multiple partitions:
ICON
1. From the "Home" screen, press the
Security icon and then the Arm Multi-
Partition icon.
2. Select the appropriate arming mode.
3. Enter the User Code authorized to access
other partition(s).
4. Highlight the partition from the list on
the screen, and press OK.
5. Select ALL to arm all partitions listed.
Security (cont'd)
ACTION
When the system is armed for Stay, Night Stay and Instant mode, the
When the system is armed for Away and Maximum mode, you will hear
ACTION
Notes:
When exit delay time expires, the screen automatically changes to indicate
the system is "Armed".
Note: If any zones are bypassed, a "Display Faults" (
displayed on this screen.
11
NOTES
Note: If Quick Arm is Not enabled in your system, a message to enter your
User Code is received.
keypad beeps 3 times.
steady beeps then rapid beeping during the last 10 seconds of Exit Delay.
When exit delay time expires, the screen automatically changes to indicate
the system is "Armed".
NOTES
•
A user may have access to some or all of the available partitions.
•
If the user code is accepted, the system displays the partitions that
the user has access to.
) icon is