Placement Of Momlthag Plate; I_Em_Wing The Mounting Plate; Finding The - GE SCB1000 Installation Instructions Manual

Installation Instructions
PLACEMENT OF THE MOUNTING PLATE
I-A--1 REMOVING THE OVEN FROM
THE CARTON/REMOVING THE
MOUNTING PLATE
_ Remoxe the box containing the instnllation
instructions, filte_, exhaust adaptor and the
small hardware bag.
_] Stnnd the oxen on its control panel side. Use a portion
ot the carton or some other material to protect the
outer case fl'om being dama ,ed
e:=..... HI Ili Mounting
IID: lllI1:!1
0@ii :!
ControlPanelSide
_]The motmting plate is attached to the back of the
oven. Remove the 2 screws holding it to the oven.
The plate will be used as the rear wall template and
fiw motmting the oven to the wall.
_] Set the oxen uptight. Remoxe and properly discard
plastic bags and Styrofl_am. Remove an) adhesixe tape
(if there is any) on the exhaust adaptor; the grease
filte_ and the power supply cord.
] (-)pen the
ox, en dooi"
_111(1
reliloxe _lny
accessolJes
fl'om inside the oxen.
I-_ FINDING THE WALL STUDS
J
_Find the studs, using one otthe fi_llowing methods:
A. Stud finde_a magnetic device which locates nails.
OR
B. Use a hammer to trip lightly across the motmting
sudime to find a solid sound. This will indicate a
stud location.
• [ [_ _Mter locating the stud(s), find the center by )robing
the wall with a small nail to find the edges of the stud.
Then place a mark halfway between the edges. The
center of any ac!iacent studs shouM
be 16" or 24" fi'om
this mark.
[3] Draw a line down the center oI the studs.
THE OVEN MUST BE CONNECTED TO AT LI_ST
ONE WALL STUD.
8