Mount The Oven - GE SCB1000 Installation Instructions Manual

Installation Instructions
_] (;enfly tile wires fl'(nn tile Reroute
i'ei//ove
gi'oox es.
the wires through grooxes on other side of the
blower unit.
Before Rerouting After Rerouting
Wires Routed ThroughRight Side Wires Routed ThroughLeft Side
[_] Rotate blower unit counterclockwise 180°
BeforeRotation After Rotation
Backof Oven
_] Roll tile blower trait 90 ° that tim blade openings
so
are ti_cing out the back of the oxen.
BeforeRolling After Rolling
Back of Oven
Back of Oven
_] I,ocate tile 2 "knockout" plates, on tile rear oxen
panel, near tile top of tile oxen.
Using tin snips, carefifllv cut tile web area fl'om tile
2 holes side-by-side (that secm'e the knockouts to the
oven). Cut all 4 webs on both rear knockouts; this will
allow the ventilation tim airflow to exhaust out the
i'eai" of
tile
o'_ eil.
S
Oven Rear Panel
Snipall 4webs
on eachknockout
panelandremove
the metal knockouts
for rearairflow.
CAUTION:
Be sure to trim the sharp edges
from the openings after removh_g the knockout plates.
_] Place the blower unit back into tile oi)ening,.
AFTER: Fan Blade
Openings Facing Back
EndB._>-
CAUTION:
Do not pull or stretch the blower
unit wiring, Make sure the wires axe not pinched,
NOTE: The blower trait exhaust openings should match
exhaust openhigs on rear of oven.
_] Secure tile blower trait to tile oven with tile screw
_emoved earlier: Replace tile blower plato in tile same
position as before with tile screws.
Retaining g
Flange 2 i
) II BlowerPlate
_,_ Screw
VB-5 MOUNT THE OVEN
FOR EASIER INS%M.IATION AND PERSONAl. SM,_ETY,
X._ERECOMMEND THAT TWO PEOPLE INSTALL
THIS OVEN.
IMPORTANT: Do not grip or use hmldle during
installation,
NOTE: If w)m" cabinet is metal, use tile m'lon grommet
aro/md tile power cord hole to prevent cutting ot tile cord.
NOTE: We recoi/li/lend rising filler blocks it tile cabinet
fl'ont hangs below tile cabinet bottom shelfi
IMPORTANT: If ftller blocks are not used, case dm_rmge
may occur from over tightenh_g screws.
17