Introduction; Installing A Memory Card; Installing The Battery Pack; Charging The Lithium-Ion Battery Pack - Garmin VIRB Elite Owner's Manual

Introduction

See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
It is your responsibility to use the device in a safe manner.
Garmin ® will not be responsible for any property damage,
injuries or deaths resulting from any use of this device in any
activities.

Installing a Memory Card

You must install a microSD™ memory card up to 64GB to use
your device. For optimal performance, use a class 10 or better
memory card.
1 Turn the D-ring counter-clockwise, and pull up to remove the
cover.
2
If necessary, remove the battery pack.
3
In the battery compartment, slide the card holder
the lens, and lift up.
4
Place the memory card
down.
5
Close the card holder.
6
Slide the card holder away from the lens to lock it.
7
Replace the battery pack.
8
Replace the battery cover, and turn the D-ring clockwise.

Installing the Battery Pack

This product contains a lithium-ion battery. To prevent the
possibility of personal injury or product damage caused by
battery exposure to extreme heat, store the device out of direct
sunlight.
1
Turn the D-ring counter-clockwise, and pull up to remove the
cover.
2 Locate the metal contacts on the end of the lithium-ion
battery.
3
Insert the battery into the compartment, contacts first.
Introduction
WARNING
with the gold contacts facing
WARNING
4
Press the battery into place.
5
Replace the battery cover, and turn the D-ring clockwise.

Charging the Lithium-Ion Battery Pack

To prevent corrosion, thoroughly dry the mini-USB port, the
weather cap, and the surrounding area before charging or
connecting to a computer.
Do not attempt to use the device to charge a battery that was
not provided by Garmin. Attempting to charge a battery that was
not provided by Garmin can damage the device and void the
warranty.
NOTE: The battery will not charge when outside the
temperature range of 32 to 114°F (0 to 45°C).
You can charge the battery using a standard wall outlet or a
USB port on your computer. You can also use an optional
battery charger accessory. Go to
more information.
toward
1
Pull up the weather cap
2 Plug the small end of the USB cable into the mini-USB port.
3
Plug the USB end of the cable into the AC adapter or a
computer USB port.
4
Plug the AC adapter into a standard wall outlet.
When you connect the device to a power source, the device
turns on. The LED is orange while the battery is charging.
5
Charge the battery completely.
The LED turns green when the battery is fully charged.
6
Remove the USB cable and fully close the weather cap.
Battery Status
Critically low battery power or missing battery
Low battery power
Remaining battery power
Charging
Fully charged
Saving Energy While Charging the Device
You can turn off the device display and all other features while
charging.
1 Connect your device to an external power source.
The remaining battery capacity appears.
2
If the device is off, hold
3
Hold for 4 to 5 seconds.
The display turns off, and the device goes into a low power,
battery charging mode.
4 Charge the device completely.
NOTICE
www.garmin.com/outdoor
from the mini-USB port
to turn on the device.
for
.
1