Advertisement
3
Allow the base to bond to the mounting surface for at least
24 hours.
4
Place the coupler
into the base.
5
Place the threaded ring
onto the base.
6
Snap the mounting arm
7
Insert a thumbscrew
thumbscrew to lock the angle of the joint.
8
Snap the camera mount
9
Insert a thumbscrew into the joint, and tighten the
thumbscrew to lock the angle of the joint.
10
Place the tab
on the back of the camera mount into the
slot in the back of the camera.
11
Squeeze the buttons
front of the camera
down, and release the buttons.
The camera should be held tightly and should not move in
the mount when properly secured.
12
If the camera feels loose in the mount, press the front of the
camera into the mount until it clicks.
over the coupler, and tighten it
into the coupler.
into the joint, and tighten the
into the top of the mounting arm.
on the sides of the mount, press the
Keys
Select to scroll through menus and settings.
Select to scroll through menus and settings.
OK
Select to choose menu options or to take a photo.
MODE
Select to scroll through modes.
Hold to turn the device on and off.
REC
Slide toward the lens to record video.
Turning On the Device
You can turn on the device using either
• Select .
The device turns on and displays the viewfinder.
• Slide REC toward the lens.
The device turns on and starts recording video.
Turning Off the Device
To prevent loss of data, always turn off the device before
removing the battery.
NOTE: You cannot turn off the device while recording video.
1
If necessary, slide REC away from the lens.
2
Hold .
appears on the screen while the device saves track log data
and turns off.
If you need to remove the battery, wait until the screen turns off
before removing the battery.
Modes
You can operate your device in several modes.
VIEWFINDER: Displays the camera viewfinder and status
information.
PLAYBACK: Allows you to view recorded videos and photos.
DASHBOARD: Displays sensor data in charts and data fields
(VIRB Elite only).
SETUP: Allows you to change camera settings.
Changing Modes
1
Select MODE to cycle through the available modes.
2
Stop selecting MODE when the desired mode appears on
the screen.
or REC.
NOTICE
3
Advertisement
