Using The Test Button - Axis 560 User Manual

High performance multi-protocol print servers for virtually all networks

Hide thumbs Also See for 560:

Table of Contents

Management and Configuration

Using the Test Button

The following operations can be performed by pressing the test button in different

sequences. Please refer to Product Overview, on page 5, to identify the location of the

test button.

Printing a test page:

• Press the test button once to print a test page.

Printing the parameter list:

• Press the test button twice to print the parameter list.

Resetting the AXIS 560/660 parameters to the factory default settings:

1. Remove the external power supply to switch off the AXIS 560/660.

2. Press and hold down the test button, while you reconnect the external power

supply. Continue to hold down the test button until the network indicator starts

to flash at one second intervals. This should take about 5 seconds.

3. Release the test button and wait until the network indicator flashes at least five

times.

4. Press and hold down the test button again until the network indicator remains

constantly lit.

5. Restart the AXIS 560/660 by disconnecting and reconnecting the external power

supply.

Note:

All parameters except the node address (NODE_ADDR.), the IP address (IP_ADDR.) and DHCP

enabled or disabled (DHCP_ENABLE.) are reset.

Please refer to the AXIS 560/660 User's Manual for more information about the test

button.

AXIS 560/660 User's Guide

Table of Contents

660