Setting Up Port Mirroring - Avaya Cajun P550R Release Notes

Configuring Port Mirroring By Using the CLI
Setting Up Port
Mirroring
610-0184-095
Use the following CLI commands to configure port mirroring on 80-
series modules. You must be in Global Configuration command
mode to enter these commands.
* Note: For information on how to enter Global Configuration
command mode, see "Accessing/Exiting the Command
Modes" in chapter 1 of Cajun P550R/P880/P882 Command
Reference Guide.
To set up port mirroring, use the following CLI command:
>(config)# set port mirror fabric_mode2
source-port <mod-port-range> mirror-port
<mod-port-spec> channel <channel> direction
{tx | rx | both} sampling {always | disable |
periodic} [max-packets=sec <max-packets-sec-
value>]
where:
<mod-port-range> is either the single port or the range of
ports that you want to mirror.
See Table 2 on page 8 for the specific port ranges that you can
mirror.
June 14, 2001
7