Renault Clio 4 Estate Handbook page 112

CRUISE CoNTRoL/SPEED LIMITER: cruise control function
2 3
Putting the function on
standby
The function is set to standby if you:
– use the switch 5 (O);
– the brake pedal;
– depress the clutch pedal or shift into
neutral if the vehicle has an auto-
matic gearbox.
In all three cases, the cruising speed
remains stored and the message
"MEMORISED" appears on the instru-
ment panel.
Standby is confirmed when indicator

light goes out.
2.28
Returning to the cruising speed
If a speed is stored, it can be recalled,
once you are sure that the road con-
ditions are suitable (traffic, road sur-
face, weather conditions, etc.). Press
switch 4 (R) if the vehicle speed is
4 5
above 20 mph (30 km/h).
When the stored speed is recalled, acti-
vation of the cruise control is confirmed
by the illumination of the
light.
Nb: if the speed previously stored is
much higher than the current speed,
the vehicle will accelerate more rapidly
to reach this threshold.
When the cruise control function is
put on standby, pressing switch 2
(+) reactivates the cruise control
function without taking into account
the stored speed: it is the speed at
which the vehicle is moving that is
taken into account.
(4/4)

warning
Switching off the function
The cruise control function is deacti-
vated if you press switch 1: in this case
a speed is no longer stored. The two in-
strument panel warning lights

go out to confirm that the function is
deactivated.
must brake by depressing the brake
pedal.
1

and
Putting the cruise control
on standby or switching it
off does not cause a rapid
reduction in speed: you