Kenmore 29-Inch Wide ELECTRIC DRYERS Owner's Manual page 15

STEP 5. Connect neutral grounding wire
and the neutral wire (white or center) of
direct wire cable under the center screw
of terminal block.
Center silver-colored
terminal block screw
Externalground
connector
White neutral wire
Bare copper wire
4-Wire Connection
with Direct Wire
Neutral
grounding wire
(green/yellow)
Strain relief
STEP 6. Place the hook-shaped end of
the wire over the terminal block screw.
The open side of the hook should face
to the right. Squeeze hook end of wire
together to form a loop.
STEP 7. Connect the other two wires
to outer terminal block screws. Use
the same method described in STEP 6.
STEP 8. Connect the direct wire cable
(bare) grounding wire to the external-
grounding conductor screw. Tighten all
terminal blo,_k screws firmly.
STEP 9. Tighten the strain relief screws.
STEP 10. Irsert tab of terminal block
cover into stot of the dryer rear panel.
Secure cow._r with hold-down screw.
Continue Installation on Page 16.
15