Beko WM 5120 W WM 5120 S Installation & Operating Instructions Manual page 32

Laundry remains wet at the end of the programme
• Excessive foam might have occurred and automatic foam absorption system might
have been activated due to too much detergent usage. >>> Use recommended
amount of detergent.
C Machine does not switch to spinning step when the laundry is not evenly
distributed in the drum to prevent any damage to the machine and to its
surrounding environment. Laundry should be rearranged and re-spun.
Machine does work. No light is on.
- The plug might not be plugged in
the mains outlet.
- Fuse may have blown.
- Electricity may be cut off.
- The "On/Off" button might have
not been pressed.
The machine did not start after the program was selected and the "Start/Pause/
Cancel" button was pressed.
The front door may be ajar.
"Washing" and "Start/Pause/Cancel" lights are flashing after the program is started.
Water may have been cut off.
A If you cannot eliminate the problem although you follow the instructions in this section,
consult your dealer or the Authorized Service Agent. Never try to repair a nonfunctional
product yourself.
- Plug should be checked.
- Fuse should be checked.
- Power should be checked.
- This button must be pressed.
You can restart your machine by pressing the
"Start/Pause/Cancel" button for a short time after
ensuring that the water is not cut off.
32
EN