Playback; Playing The Connected Component - Integra DTR-30.4 Instruction Manual

Playback

The on-screen menus appear only on a TV that is
connected to HDMI OUT MAIN. If your TV is
connected to other video outputs, use the AV
receiver's display when changing settings.
This section describes the procedure for using the
remote controller, unless otherwise specified.

Playing the Connected Component

■
Operating with the remote controller
Input Selector
Receiver
VOL /
Listening mode buttons
1 Press Receiver followed by an Input Selector
button.
2
Start playback on the source component.
See also:
• "Playing an iPod/iPhone via USB" (➔ page 24)
• "Playing a USB Device" (➔ page 25)
• "Listening to vTuner Internet Radio" (➔ page 25)
• "Registering Other Internet Radio" (➔ page 26)
• "Playing Music Files on a Server" (➔ page 27)
• "Remote Playback" (➔ page 28)
• "Listening to AM/FM Radio" (➔ page 29)
• "Playing Audio and Video from Separate Sources"
(➔ page 31)
• "iPod/iPhone Playback via Onkyo Dock"
(➔ page 72)
• "Controlling Other Components" (➔ page 74)
3
To adjust the volume, use VOL / .
En-22
Turning On & Basic Operations
4
Select a listening mode and enjoy!
See also:
• "Using the Listening Modes" (➔ page 35)
■
Operating on the AV receiver
Input selector buttons
Listening Mode
1 Use the input selector buttons to select the input
source.
2
Start playback on the source component.
3
To adjust the volume, use the Master Volume
control.
4 Select a listening mode and enjoy!
■
Screen Saver
If there is no video signal on the current input source and
no operation for a specific time (three minutes by
default), a screen saver automatically comes on.
Tip
• The time until the screen saver activates itself can be changed
in the "Screen Saver" setting (➔ page 63).
• The screen will return to its previous state if the AV receiver is
operated.
Master Volume