Table of Contents
Advertisement
Important Note Regarding Video Playback
The AV receiver can upconvert component video and
composite video sources for display on a TV connected to
the HDMI output(s). However, if the picture quality of the
source is poor, upconversion may make the picture worse
or disappear altogether.
In this case, try the following:
1
If the video source is connected to a component
video input, connect your TV to COMPONENT
VIDEO OUT.
If the video source is connected to a composite video
input, connect your TV to MONITOR OUT V.
2
On the main menu, select "Input/Output Assign",
and then select "Component Video Input"
(➔ page 51).
If the video source is connected to COMPONENT
VIDEO IN 1, select the relevant input selector, and
assign it to "IN1".
If the video source is connected to COMPONENT
VIDEO IN 2, select the relevant input selector, and
assign it to "IN2".
If the video source is connected to a composite video
input, select the relevant input selector, and assign it to
"- - - - -".
Tip
• To by-pass the upconversion, set the "Picture Mode" setting to
"Direct" (➔ page 60).
En-84
Appendix
Hide quick links:
Advertisement
Table of Contents
