Troubleshooting - Emerson Smart Wireless THUM Adapter Quick Installation Manual

Smart Wireless THUM Adapter

Troubleshooting

If the device is not operating properly, refer to the troubleshooting section of the manual. The
most common cause of incorrect operation is the Network ID and Join Key. The Network ID
and Join Key in the device must match that of the Smart Wireless Gateway.
The Network ID and Join Key may be obtained from the Smart Wireless Gateway on the
Setup>Network>Settings page on the web server. The Network ID and Join Key may be
changed in the wireless device by using the following Fast Key sequence.
Function
Wireless Setup
R
EFERENCE
NOTE:
In order to communicate with a Field Communicator, the wired device must be
powered.
Table 1. THUM Adapter Fast Key Sequence
Function
Device Info
Guided Setup
Manual Setup
Wireless
20
Key Sequence
I
NFORMATION
Key Sequence
2, 2, 4, 3
2, 1
2, 2
2, 2, 1
1, 4
Manufacturer, Model, Final Assembly Number, Universal,
Field Device, Software, Hardware, Descriptor, Message,
Date, Model Number I, II, III, SI Unit Restriction, Country
Configure, Guided Setup, Join Device to Network,
Configure Update Rate, Zero Trim, Configure Device
Display, Configure Process Alarms
Configure, Manual Setup, Wireless, Pressure, Device
Temperatures, Device Information, Display, Other
Network ID, Join Device to Network, Configure Update
Rate, Configure Broadcast Power Level, Power Mode,
Power Source
Quick Installation Guide
00825-0100-4075, Rev DA
Menu Items
Smart Power, Network ID, Set Join
Key, Radio State
Menu Items
July 2011