Replacing the Chassis Intrusion Switch
To replace the chassis intrusion switch, follow the
Resetting the Chassis Intrusion Detector
1. Enter system setup by pressing <F2> during the computer's POST.
For instructions on using system setup, see the User's Guide.
2. Under the System Security tab, reset the Chassis Intrusion option by pressing the left- or right-arrow key to select Reset. Change the setting to
Enabled, Enabled-Silent, or Disabled.
NOTE:
The default is Enabled-Silent.
NOTE:
If a setup password has been assigned by someone else, contact the network administrator for information on resetting the chassis intrusion
detector.
3. Press <Alt><B> to restart the computer and implement your changes.
Back to Contents Page
"Removing the Chassis Intrusion
Switch" procedures in reverse order.