I Hookups; Connecting To A Tv Without A/V Terminals; Connecting To A Tv With A/V Terminals - Sylvania DVC860D Owner's Manual

CAUTION:
¡ Be sure to turn off the DVD/VCR COMBINATION UNIT and equipment to be connected.
¡ Read through the operation manual for the equipment to be connected.
¡ Be sure that the colors of the jacks and plugs match up when using VIDEO/AUDIO cables.
¡ Be sure to keep the DVD/VCR COMBINATION UNIT connection cables separate from the TV antenna cable
when you install the DVD/VCR COMBINATION UNIT, because it may cause electrical interference when you
are watching television programs.

CONNECTING TO A TV WITHOUT A/V TERMINALS

1. Disconnect the AC power cord of the TV from the
AC outlet.
2. Disconnect the antenna or cable from the TV.
3. Connect the antenna or cable to the ANT-IN jack of
the DVD/VCR COMBINATION UNIT.
4. Connect the DVD/VCR COMBINATION UNIT to
the TV using the RF cable.
5. Plug the AC power cords of the DVD/VCR COM-
BINATION UNIT and TV into the AC outlets.
RF OUTPUT CHANNEL for DVD/VCR
1. Connect the DVD/VCR COMBINATION UNIT to a TV using RF cable (see above steps).
2. Select channel 3 on your TV.
3. Press PLAY.
¡ If noise appears, change the RF output channel of the DVD/VCR COMBINATION UNIT to channel 4 by
pressing PLAY on the VCR for 3 seconds during playback.
¡
There is case that the RF output channel does not change by situation (For example, when you adjust tracking using
( )
CHANNEL ).
In this case, stop the playback, and start the playback again. After that, press PLAY on the VCR for 3 seconds.
¡
If there is a power failure or the DVD/VCR COMBINATION UNIT is unplugged for more than 30 seconds, the RF
output channel setting will return to CH3.
Note to CATV system installer
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that pro-
vides guidelines for proper grounding and, in particular, specifies that the cable ground should be connected
to the grounding system of the building, as close to the point of cable entry as practical.

CONNECTING TO A TV WITH A/V TERMINALS

Antenna/Cable signal
A/V-compatible or
wide screen TV
Notes
¡ Connect the DVD/VCR COMBINATION UNIT directly to a TV. If the A/V cables are connected into a
VCR first, picture may be distorted due to the copy protection system.
HOOKUPS
DVD/VCR VCR
AUDIO OUT AUDIO IN
ANT-IN
L L
R R
ANT-OUT
VIDEO OUT VIDEO IN
To ANT. IN
of TV
To VIDEO INPUT jack To VIDEO OUT jack
To Right (red) and Left (white)
To AUDIO INPUT jacks To AUDIO OUT jacks
[VHF/UHF
[Indoor antenna]
combination antenna]
[Cable box or satellite box]
IN
OUT
From Cable or
Satellite Company
S-VIDEO
OUT
– 13 –
[Back of the DVD/VCR]
[Back of the
UHF/VHF combination TV]
RF cable
OR
DVD/VCR VCR
(supplied)
AUDIO OUT AUDIO IN
ANT-IN
L L
OR
R R
ANT-OUT
VIDEO OUT VIDEO IN
DVD
COMPONENT AUDIO DIGITAL
VIDEO OUT OUT AUDIO OUT
Y
Cb L
COAXIAL
Cr R
UHF/VHF
[Fig. 1]
EN
1L25