Table of Contents
Advertisement
Installing System Board Options: Dell OptiPlex GX1 Low-Profile Managed PC Systems
screwdriver.
5. Install the new battery.
Orient the battery with the side labeled "+" facing up (see Figure 11). Then insert the battery into the
socket, and snap it into place.
Figure 11. System Battery and Battery Socket
6. Replace the expansion-card cage as described in
7.
Replace the computer
and turn them on.
NOTE: If Enabled, the
at the next system start-up:
ALERT! Cover was previously removed.
8. Enter the
System Setup program
9. Enter the correct time and date through the System Setup program's Time and Date categories. Also,
use the copy you made in step 1 to restore the correct settings for other system configuration
information. Then exit the System Setup program.
10. Turn off your computer, and unplug it for at least 10 minutes.
11. After 10 minutes, plug in the computer, turn it on, and enter the System Setup program. If the time and
date are still incorrect, see the chapter titled "Getting Help" in your Diagnostics and Troubleshooting
Guide for instructions on obtaining technical assistance.
Back to Contents Page
file:///C|/infodev/2013/eDoc/OpGX1/SQRG/options.htm[2/21/2013 11:53:02 AM]
cover, and reconnect your computer and peripherals to their electrical outlets
Chassis Intrusion
and confirm that the battery is operating properly.
"Replacing the Expansion-Card
option will cause the following message to be displayed
Cage."
Advertisement
Table of Contents
