CrimeStopper Platecam SV-5350 Installation Instructions

Hide-away bracket license plate camera

Table of Contents

Download this manual

The SV-5350 is a special designed license plate metal bar back up camera with a super wide

view angle. The SV-5350 is designed to be installed in the back of the license plate on any

vehicle. It is easy to install with no drilling required, requiring minimal installation time. This

uniquely designed product can be used for any passenger car, SUV and Van. It can also be

used on many large Semi Trucks, School Buses, and Transit Buses

FEATURES:

Revolutionary design integrates a Color rear vision camera with your rear license plate

Enhance the look of your Car, SUV, Truck or Van.

The 170 ultra wide-angle CCD color camera provides rear images in real time and

eliminates the dangerous "blind-spot" directly behind your vehicle when backing.

Works well in day or night, on most vehicles.

Simple installation: No major tools required. Video monitor required, not included.

The plate cam easily connects with other SecurView products such as the SV-8200 and

SV-8400 3.5" LCD monitors. It can also be integrated with your existing OEM or

aftermarket LCD/TFT displays.

The PlateCam™ is designed for vehicles in which the license plate location is centered

and above the level of the rear bumper. The PlateCam™ may not perform well on

vehicles with low or offset license plate positions.

Installation INSTRUCTIONS:

Hide-Away Bracket

License Plate Camera

SV-5350

Table of Contents

Do you have a question about the Platecam SV-5350 and is the answer not in the manual?

Page 1 The SV-5350 is a special designed license plate metal bar back up camera with a super wide view angle. The SV-5350 is designed to be installed in the back of the license plate on any vehicle. It is easy to install with no drilling required, requiring minimal installation time. This uniquely designed product can be used for any passenger car, SUV and Van.
Page 2 2. The SV-5350 is designed to work best on vehicles that have a license plate located at the center and above the rear bumper. If your vehicle has a plate location that is offset to the left side, right side, or your plate is located under the bumper then the PlateCam™...
Page 3 Check to see if you can control the settings in your monitor to turn off the mirror image feature. If not, the SV-5350 has a wire that can be grounded to reverse the image back to normal. (See Wiring Diagram) WIRING: 1.
Page 4 Federal Motor vehicle codes with regards to modifications of vehicle license plates. The manufacturer of the PlateCam™ assumes no liability or responsibility whatsoever with regards modifications of the license plate. www.crimestopper.com email@crimestopper.com Phone (800) 998-6880 FAX (805) 581-9500 © 2009 Crimestopper Security Products...