Table of Contents
Advertisement
Chapter 6 - Basic Configuration Guide
Suggested for IPX
You may want to set your own network numbers, rather than using the
autoconfigured values. You may also want to turn off unused frame
types.
CV: Use the IPX Routing: Ethernet 0 Dialog Box.
TB: Use configure and set keywords in the IPX Ethernet 0 (and/or
Ethernet 1) section.
AppleTalk Protocol
Required for AppleTalk
There are generally no required changes from the shipping Ethernet
configuration for AppleTalk. The Ethernet interface will autoconfigure
to use AppleTalk Phase 2, and will autoadapt to conditions on the
Ethernet.
Suggested for AppleTalk
You may want to set your own network numbers, rather than using the
autoconfigured values. You may also want to use more meaningful
zone names.
CV: Use the AppleTalk Routing: Ethernet 0 Dialog Box.
TB: Use configure and set keywords in the AppleTalk Phase 2
Ethernet 0 (and/or Ethernet 1) section.
DECnet Protocol
Required for DECnet
The router's shipping configuration does not have DECnet turned on.
You must turn it on and set several DECnet parameters.
•
Set DECnet on (globally, and for this port)
•
Set DECnet area
•
Set DECnet node
CV: Use the DECnet Routing Dialog Box (under Global/DECnet
Routing) and the DECnet: Ethernet Dialog Box.
TB: Use configure and set the Enabled, Area, and Node keywords in
the DECnet Global section.
Note: Setting DECnet on for any port with the command line also
v
sets DECnet on globally. In CompatiView you must set a global
parameter and a port-specific parameter.
21
Advertisement
Table of Contents
Need help?
Do you have a question about the MicroRouter 2270R and is the answer not in the manual?
Questions and answers