Display Assembly - Dell Latitude C540 Service Manual

Display Assembly, Display Latch, and Hinge Covers: Dell Latitude C540/C640 Service Manual
Back to Contents Page
Display Assembly, Display Latch, and Hinge
Covers
Dell™ Latitude™ C540/C640 Service Manual

Display Assembly

Display Latch
Hinge Covers
Display Assembly
NOTICE: You must remove the display assembly before you remove the palm
rest.
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove
any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an
unpainted metal surface on the computer.
NOTICE: Read
procedureDisplay Assembly
1. Remove the hard
2. Remove the center control
3. Remove the keyboard.
4. Close the display.
5. From the back of the computer, remove the five M2.5 x 5-mm screws labeled "circle D."
6. Open the display assembly approximately 180 degrees and support the display assembly so that it
does not open past this position.
7. Remove the two M2 x 3-mm screws on the EMI shield bracket, which is attached to the display-feed
flex cable.
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/...0C640/C540%20C640_SERVICE_MANUAL/display.htm (1 of 11)6/21/2004 1:27:14 AM
"Preparing to Work Inside the
drive.
cover.
Computer" before performing the following