Flashing The Bios - Dell Latitude C400 Service Manual

Flashing the BIOS : Dell Latitude C400 Service Manual
Back to Contents Page

Flashing the BIOS

Dell™ Latitude™ C400 Service Manual
Perform the following steps to update the BIOS:
1. Make sure that the AC adapter is plugged in and that the main battery is installed properly.
2. Turn on the computer. The following error message appears:
System hardware failures: #0010
Strike the F1 key to shutdown
3. Instead of pressing <F1>, insert the Flash BIOS update floppy disk or CD into the appropriate
drive and press <F6>, and then press <F4>. The computer displays the following message on
the screen:
Failure override
Processor update failure. Reload current BIOS
Strike the F1 key to continue, F2 to run the setup utility.
4. Press <F1>. The computer continues to boot and updates the new BIOS.
5. Press <F2> to enter the system setup program and reset the boot sequence with the
appropriate drive, if required.
6. Press <ESC> to exit the system setup program.
7. Remove the Flash BIOS update floppy disk or CD from the drive and restart the computer.
Back to Contents Page
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/LAPTO...d%20ok/Latitude/C400/C400_SERVICE_MANUAL/bios.htm6/21/2004 1:20:16 AM