Fujitsu Screen Protector FMWSP8 Installation Instructions

FMWSP8
Screen Protector

Installation Instructions

Stylistic LT
The FMWSP8 screen protector can be installed on
the Stylistic LT pen tablet display screen or on the
display window of the FMWCC39 harsh
environment case. Note the following:
• Before installing a new screen protector, remove
any screen protector that is already installed. A
notch in the corner of the screen protector allows
you to slide your fingernail or a firm, pliable
implement (such as a credit card) under the screen
protector for removal. Do not use a metal
implement; it could scratch the screen.
• To ensure good adhesion, clean the display screen
with a soft cotton cloth dampened with denatured
alcohol before installing the screen protector. When
the alcohol dries, it may leave streaks on the
screen. If streaking occurs, buff the screen gently
with a clean, dry cloth to remove the streaks.
1. For installation on the harsh environment case
(HEC) only: Remove edge from screen protector,
as shown in Figure 1.
Figure 1. Removing Edge for HEC Installation
2. Peel the protective film from the adhesive side of
the screen protector, as shown in Figure 2.
Figure 2. Peeling Protective Film
Stylistic LT is a trademark of Fujitsu Personal Systems, Inc. © 1999 Fujitsu Personal Systems, Inc.
6/99
3. Install the screen protector on the pen tablet or
harsh environment case. Apply the adhesive side to
the screen with the notch in the lower left corner, as
shown in Figure 3. Apply pressure along the edges
of the screen protector with your finger. (Avoid
lifting the screen protector from the screen after it is
installed. The adhesive requires 48 hours to cure
properly.)
Figure 3. Installing the Screen Protector
4. Remove the protective film from the top of the
screen protector, as shown in Figure 4.
5. Wipe the exposed surface of the screen protector
with a clean dry cloth to remove any adhesive left
behind by the protective film.
Figure 4. Removing the Protective Film
58-0661-00A