Advertisement
NOTE: The following
assemblies
should be done
with Cabinet
upright.
Step 9.
Attach Hinges to Leaf Supports with
(4) #8x5/8" Flathead screws each.
tap Magnet with hammer, (as shown
in FIG. 8A)o Attach Bronze Strikes to
outside of Left and Right sides with #5xl/2"
Flathead Screw as in FiG. 8. Attach Self
Sticking Rubber Tab to the top outside edge of
each Leaf Support, as in FIG. 8A. Attach Leaf
Support to right and Left Sides with (8) #8x5/8"
Flathead Screws. Wings should fold to back of
cabinet (see FIG. 8).
#8x5/8"
Round
Flathead
Magnet
Screw
FIG. 8A
Self Sticking
Rubber Tab
CAUTION: When applying the SELF STICKING
RUBBER TAB,
CAREFULLY REMOVE THE WHITE PAPER BACKING ONLY.
Step 10.
Attach the Front Support to the cabinet Partition
using (2) #5xl/2"
Flathead Screws (as shown in
FIG. 9). Tension can be adjusted on the Front
Support by tightening
the adjustment
screw (as
shown in FIG. 9A).
FIG. 9
Partition
#5X1/2"
[=----_ _ _ __,_
Flathead Screws _"_\_
Front Support
J_
FIG. 8
Flathead
Screws
Tension
Adjustment
rt
Step 11.
Turn the Top over (with Platform hanging down)
and guide the Connecting
Bolts into the holes on
the top edge of the Sides and Partition. Open
leaves to rest on Leaf Supports.
Reach through
the opening in the Top and turn Cams to the
Locked position (as shown in FIG. 10). Now reach
into the Compartment
and Lock the Cams in the
same manner.
Page 7
Top/Base Assembly
98200-7
98201-7
Advertisement
