Advertisement
Installing Sewing Machine in your new Cabinet.
It may be helpful to read the directions for operating
the mechanism
before proceeding
with the following
steps. See page 11, and FIG. 12, on this page.
STEP1.
STEP2.
STEP 3.
STEP4.
STEP 5.
STEP6.
To prevent damage to Cabinet surface, place
cushioning material just to the left
of cut-out. Lay the sewing machine on its
back, on top of cushioning material.
With Platform in the flatbed position,
place Plastic insert into position, making
sure the ruler is facing front• This will aid
you in positioning the sewing machine.
Feed machine receptacle cord from the
machine control pedal, up through the slot on
the right side of the machine platform•
Insert machine receptacle into terminals
provided on the right side of the machine; (this
may vary with some machines).
Thread the two Headmounting Bolts (provided)
into the two threaded holes located on the
bottom of your machine; twist tight to the
collar; (number and type of Bolts may vary
with some machines).
With the plastic insert in place (see page 11)
and the front left corner of the machine
almost touching the front left corner of the
Insert, lower machine onto the Platform, aligning
bolts with machine onto the Platform; (some
machines may require new holes to be drilled).
Next, secure machine to Platform with Washers
and Wing Nuts, from underneath Platform.
See. FIG. 11 and 11A.
While holding machine, lower it into storage
position, raise it up to free the arm (to check
its operation) then lower it back to the flatbed
position. Read operating instructions on page 11 first•
Maintenance
of Cabinet:
Clean as you do your other fine furniture,
using a
soft cloth and polish.
STEP3
_FIG.
FIG. 11A
Understanding
How Your Mechanism
Works:
FIG. 12
L_
F__
J
Free Arm
Flatbed
[
",j'
• .
Correct poeltlo
For Storage
IMPORTANT: To move smoothly from one position to another, make sure you do so slowly with both hands,
and always make sure you hear the CLICK after each position change. The machine may be lowered for proper clearance
from closed leaf while in the storage position by adjusting
stopper bolt on back panel•
98200-10
Page 10
98201-10
Advertisement
