Fujitsu LifeBook S2210 User Manual page 68

Problem
Memory Problems
The System Properties
screen does not show the
correct amount of installed
memory.
Modem Problems
Messages about modem
operation.
USB Device Problems
You have installed a USB
device. Your LifeBook
notebook does not recog-
nize the device, or the
device does not seem to
work properly.
PC Card Problems
A card inserted in the PC
Card slot does not work or
is locking up the system.
Power Failures
You turn on your
LifeBook notebook and
nothing seems to happen.
Possible Cause
Your memory upgrade module
is not properly installed.
You have a memory failure.
Messages about modem opera-
tion are generated by whichever
modem application is in use.
The device is not properly
installed.
The device may have been
installed while an application
was running, so your notebook
is not aware of its installation.
Your device may not have the
correct software driver active.
The card is not properly
installed.
The card may have been
installed while an application
was running, so your notebook
is not aware of its installation.
Your software may not have the
correct software driver active.
You may have the wrong I/O
address selected for your PC
Card device.
Your PC Card device and
another device are assigned the
same I/O address.
The installed primary battery is
completely discharged or there
is no optional second battery or
power adapter installed.
The primary battery is installed
but is faulty.
T r o u b l e s h o o t i n g
Possible Solutions
Remove and re-install your memory upgrade
module. (See Memory Upgrade Module on page 45
for more information)
Check for Power On Self Test (POST) messages.
(See Power On Self Test Messages on page 62 for more
information)
See your application software documentation for
additional information.
Remove and re-install the device. (See Device Ports
on page 47 for more information)
Close the application and restart your notebook.
See your software documentation and activate the
correct driver.
Remove and re-install the card. (See PC Cards on
page 41 for more information)
Close the application and restart your notebook.
See your software documentation and activate the
correct driver.
See your card documentation to determine the
correct address. Change the BIOS settings. (See
BIOS Setup Utility on page 27 for more information)
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
Check the Status Indicator Panel to determine the
presence and condition of the batteries. (See Status
Indicator Panel on page 12 for more information)
Install a charged battery or a Power adapter.
Use the Status Indicator panel to verify the presence
and condition of the batteries. (See Status Indicator
Panel on page 12 for more information) If a battery is
indicating a short, remove that battery and operate
from another power source or replace that battery.
57