Setting The Clock; Tips For Saving Energy - Daikin FT50BSG Operational Manual

Preparation Before Operation
Indoor unit
I Setting the photo-catalytic
deodorizing & air cleaning filter
1
Open the front grille.
G Hold the grille by the tabs on the two
sides and lift it until it stops with a click.
(about 60°)
2
Pull out the air filters.
G Push upwards the
tab at the center of
each air filter, then
pull it down.
3
Set the photo-catalytic deodorizing
& air cleaning filter.
G Attach an photo-catalytic deodorizing &
air cleaning filter to each air filter.
(See page 12.)
4
Set the air filters in their original
positions and close the front grille.
G Operation without air filters may result in
troubles as dust will accumulate inside
the indoor unit.
NOTE

Tips for saving energy

G Be careful not to cool the room too much.
Keeping the temperature setting at a
moderate level helps save energy.
Recommended temperature setting
For cooling: 26°C – 28°C
G Cover windows with a blind or a curtain.
Blocking sunlight and air from outdoors
increases the cooling effect.
G Clogged air filters cause inefficient
operation and waste energy. Clean them
once in about every two weeks.
8
I Setting the clock
1
Press .
AM
2
Press to set the clock to the
TIMER
present time.
PM
G Holding down (
increases or decreases the time display.
3
Press .
PM
I Turn the breaker ON
G Turning ON the breaker opens the flap, then
closes it again. (This is a normal procedure.)
Please note
G The air conditioner always consumes 15 – 35
watts of electricity even while it is not operating.
G If you are not going to use the air conditioner
for a long period, for example in spring or
autumn, turn the breaker OFF.
G Use the air conditioner in the following conditions.
Mode Operating conditions
Outdoor temperature : 21 to 46 °C
Indoor temperature : 18 to 32 °C
COOL
Indoor humidity : 80% max.
Outdoor temperature : 21 to 46 °C
Indoor temperature : 18 to 32 °C
DRY
Indoor humidity : 80% max.
is displayed.
AM
blinks.
) or ( ) button rapidly
blinks.
(Now the clock is set.)
If operation is continued out of this range
•A safety device may work
to stop the operation.
•Condensation may occur
on the indoor unit and drip.
•A safety device may work
to stop the operation.
•Condensation may occur
on the indoor unit and drip.