Operation Of The Monitor - Fujitsu Siemens Computers 21P4 Owner's Manual

Ê
Connect one of the connectors of the data cable to the D-SUB connector on the monitor (2)
and secure the plug-in connection by tightening the safety screws.
If you use a data cable with BNC connectors instead of the supplied data cable, you
i
should perform the following step:
Ê
Connect the BNC connectors of the data cable to the appropriate BNC connectors
on the monitor (3), correct order from left to right: Red-Green-Blue-H-V, and secure
the plug-in connections by locking the bayonet catches.
Ê
Change the video signal in the OSD menu (function D-SUB/BNC).
Ê Connect the 15-pin connector of the data cable to the (active) monitor port on the computer and
secure the plug-in connection by tightening the safety screws.
If your computer has two monitor ports ("onboard" screen controller and separate
i
graphics card), the monitor port for the separate graphics card is usually active.
Ê
Plug the power cable supplied into the power connector of the monitor.
Ê Plug the power connector of the computer into a properly grounded mains outlet.
When you start working with your monitor for the first time you should install the
i
appropriate graphics drivers for your application software. Details of how to do this are
provided in the documentation on your graphics card/the associated driver software.

Operation of the monitor

1
A26361-K886-Z100-1-5E19
1 = Buttons for the OSD menu
(On-Screen-Display)
2 = Power indicator
3 = Power button
2 3
Colour monitor 21P4
English - 9