GE JB250RFSS Dimensions And Installation Information

JB250RF/GF
GE 30" Free-Standing Electric Range
®
Dimensions and Installation Information (in inches)
Receptacle Locations
Locally approved flexible service cord or conduit must be used
because terminals are not accessible after range installation.
See shaded area in drawing for location of electrical outlet box.
Recommended outlet locations allow range to be installed directly
against wall.
Note: 30" ranges conform to U.L. requirements for 0" spacing
from adjacent walls below countertops. To reduce possibility of
scorching walls, engineering recommends a minimum of 1-1/2"
spacing to allow for possible extended, high-heat, no-load
heating element operation.
Installation Information: Before installing, consult installation
instructions for current dimensional data and additional
requirements.
KW Rating
240V 12.1
208V
9.1
Breaker Size
40 Amps
†
Note: Check local codes for required breaker size.
†
For answers to your Monogram or GE
®
appliance questions, visit our website at
geappliances.com or call GE Answer Center
service, 800.626.2000.
Acceptable electrical
outlet area
29-7/8
®
®
30
2-1/2
25
11
47
35-3/4
to
36-1/2
25-1/2
w/o handle
28
w/handle
47-7/8
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Specification Revised 7/13
2-1/2
7-1/2
Listed by
Underwriters
Laboratories
321567